sugarasfen.blogg.se - Fix straight line bug wacom bamboo tablet windows 10

#Fix straight line bug wacom bamboo tablet windows 10 how to

In short, check that both your GPU and cable support the resolution you want.

Your graphics card needs to support at least HDMI 1.3 to handle a 4K 60Hz resolution.

For example, you need a category 3 HDMI cable to run a 4K display at 60Hz.

HDMI cables come in different categories, and the HDMI output on your graphics card may only support specific resolutions.

If this doesn't work, I would try some of the other solutions but ONLY opening it as a 2nd-to-last resort, the last resort being buying a new pen for ~$40 (only select models are compatible with the CTE-650 model if that's what you have, so be sure to call Wacom first). The video that helped me fix it: Official Wacom instructional video on replacing pen nibs The pen returned to its normal state after my third round of tapping and blowing into it. Repeat this while testing the pen with a quick application like Microsoft Paint and see if the problem still occurs. The first thing I would try is to remove your pen nib with tweezers or gently with pliers, then blow into the pen like you would an N64 cartridge and tap the pen against the table a few times. This is probably due to unwanted debris or muddled components near the sensor. The problem is usually in the pen itself, rather than in the tablet the pressure sensor inside is stuck in its depressed state thus causing it to essentially be in constant "left click" or "draw" mode as soon as either end of the pen comes near the tablet. Although the users here have offered some nice solutions, the one that worked for me seems to be the simplest and is similar to 's. The sensor assembly is clearly visible in the eighth image down.Ĭame across this Q&A thread from Google Search when I had the same problem.

#Fix straight line bug wacom bamboo tablet windows 10 how to

There's a good walkthrough on how to disassemble the stylus at: However, it doesn't seem to matter which way I put it back in, oddly enough. When you go to replace it, the single metal face was towards the inside of the tan mount, facing the brass contact surface. When I first got the assembly apart, that magic disk was flung out. Put it all back together, and with any luck, it'll start working like new again. This is what is triggering the pressure sensor even without a Nib in the pen.įlip it over so the side developing a bump is now towards the white Nib holder, with the gasket between that disk shaped thing and the rubber pad. What I found is the black rubber pad starts to bend inward in the same shape as the rounded half of the Nib bracket, by just a few thousandths of an inch. All of the small parts inside are unsecured, and will probably fall out, so try to separate the two halves slowly. this assembly can be opened by gently slipping a fingernail into the small gap around the lip of the grey half, where the two meet, and carefully working the clips free. They're both made of six small pieces: The two large grey and tan halves of the assembly, a white Nib holder, a rubber pad, an extremely thin spacer, and some sort of magical disk thing.

If you take the stylus apart, you'll see the nib/pressure sensor/iron core and coil assembly at both ends of the fragile board. If your warranty is expired or you don't mind voiding it, I think I've finally found a solution to this problem.